12.3.4 Fan Control
This function is used to set the running mode of the fan for the heat sink.
The fan for the capacitor is switched on and running all the time
once the frequency converter is powered on.
Code Name Setting range Default Min. Attri.
C0.50 Fan control
0: Automatically controlled
1: Always on
0 – Run
● 0: Automatically controlled
The fan for the heat sink is by default switched on / off automatically accord-
ing to the temperature of the heat sink. In this mode, the noise level of the
frequency converter can be reduced.
● 1: Always on
The fan for the heat sink is switched on and running all the time once the fre-
quency converter is powered on. In this mode, a better cooling performance
of the frequency converter can be achieved.
Bosch Rexroth AG
Functions and Parameters
EFC x610 Series
126/389
DOK-RCON03-EFC-X610***-IT05-EN-P
To Next Page
Loading...
Need help?
General
