REXROTH EFC 3610 Series - Error 53 (Fdi-): no Valid Process Data; Error 54 (Pce-): Remote Control Communication Error; Error 55 (Pbre): Parameter Backup; Restore Error; Error 56 (Pref): Parameter Restore Error after Firmware Update

13.4.37 Error 53 (Fdi-): No Valid Process Data
Possible reason Solution
No valid process data is received from remote communica-
tion server, the remote communication server may be turned
off
Check remote communication server
13.4.38 Error 54 (PcE-): Remote Control Communication Error
Possible reason Solution
Error if communication to IndraWorks/ConverterWorks is
lost during remote control
● Check communication status between
frequency converter and IndraWorks/
ConverterWorks
● Contact with service
13.4.39 Error 55 (PbrE): Parameter Backup / Restore Error
Possible reason Solution
Error occurs during parameter backup/restore process Contact with service
13.4.40 Error 56 (PrEF): Parameter Restore Error after Firmware Update
Possible reason Solution
Error occurs if parameter settings cannot be restored af-
ter firmware update
Contact with service
13.4.41 Error 60 (ASF-): Application Firmware Error
Possible reason Solution
Error message if the application firmware was not loaded
correctly or trail use is over
Contact with service
13.4.42 Error 61...65 (APE1...APE5): Application Error
Possible reason Solution
Application error
Error which can be thrown by the applica-
tion, description in application manual
Bosch Rexroth AG
Diagnosis
EFC x610 Series
250/389
DOK-RCON03-EFC-X610***-IT05-EN-P