which measures of risk reduction for personal safety depend on electrical,
electronic or programmable control systems.
● The information given in the application documentation with regard to the use
of the delivered components contains only examples of applications and sug-
gestions.
The machine and installation manufacturers must
– make sure that the delivered components are suited for their individual ap-
plication and check the information given in this application documentation
with regard to the use of the components,
– make sure that their individual application complies with the applicable
safety regulations and standards and carry out the required measures,
modifications and complements.
● Commissioning of the delivered components is only allowed once it is sure
that the machine or installation in which the components are installed com-
plies with the national regulations, safety specifications and standards of the
application.
● Operation is only allowed if the national EMC regulations for the application
are met.
● The instructions for installation in accordance with EMC requirements can be
found in the section on EMC in the respective application documentation.
The machine or installation manufacturer is responsible for compliance with
the limit values as prescribed in the national regulations.
● The technical data, connection and installation conditions of the components
are specified in the respective application documentations and must be fol-
lowed at all times.
National regulations which the user must take into account
● European countries: In accordance with European EN standards
● United States of America (USA):
– National Electrical Code (NEC)
– National Electrical Manufacturers Association (NEMA), as well as local engi-
neering regulations
– Regulations of the National Fire Protection Association (NFPA)
● Canada: Canadian Standards Association (CSA)
● Other countries:
– International Organization for Standardization (ISO)
– International Electrotechnical Commission (IEC)
EFC x610 Series
Bosch Rexroth AG
Safety Instructions for Electric Drives and Controls
DOK-RCON03-EFC-X610***-IT05-EN-P
5/389
To Next Page
Loading...
Need help?
General
