To Next Page

To Previous Page

5.System Maintenance

187

Exiting Service Mode

Press the Exit key on the touch-panel.

Service Mode Lock/Unlock

At locations where the machine contains sensitive data, the customer engineer cannot operate the machine until the

Administrator turns the service mode lock off. This function makes sure that work on the machine is always done with the

permission of the Administrator.

1. If you cannot go into the SP mode, ask the Administrator to log in with the User Tool and then set "Service Mode

Lock" to OFF after he or she logs in:

User Tools > System Settings > Administrator Tools > Service Mode Lock > OFF

 This unlocks the machine and lets you get access to all the SP codes.

 The CE can service the machine and turn OFF then ON the machine power. It is not necessary to ask the

Administrator to log in again each time the main power is turned ON.

2. Go into the SP mode and set SP5-169 to "1" if you must use the printer bit switches.

3. After machine servicing is completed:

 Change SP5-169 from "1" to "0".

 Turn OFF then ON the machine power. Tell the administrator that you have completed servicing the machine.

 The Administrator will then set the "Service Mode Lock" to ON.

PM Counter/ Firmware Update

PM Counter and Firmware Update can be entered in the SP mode main screen.

 PM Counter: PM counters for each PM part

 Firmware Update: Immediate remote update and remote update at next visit

How to Check the PM Counter

Ricoh M0A0 User Manual

Questions and Answers: