Ricoh M0A0

3.Appendices: SP Mode Tables
165
bit 4
DFU
-
-
bit 5
DFU
-
-
bit 6
DFU
-
-
bit 7
DFU
-
-
1001
[Bit Switch]
005
Bit Switch 5 Settings
0
1
bit
0
DFU
-
-
bit
1
Multiple copies if a paper size or type mismatch occurs
Disabled
(single copy)
Enabled
(multiple)
If a paper size or type mismatch occurs during the printing of multiple copies, only a single copy is
output by default. Using this BitSw, the device can be configured to print all copies even if a paper
mismatch occurs.
bit
2
Prevent SDK applications from altering the contents of a
job.
Disabled
Enabled
If this switch is enabled, SDK applications will not be able to alter print data. This is achieved by
preventing SDK applications from accessing a module called the "GPS Filter".
Note: The main purpose of this switch is for troubleshooting the effects of SDK applications on data.
bit
3
[PS] PS Criteria
Pattern3
Pattern1
Change the number of PS criterion used by the PS interpreter to determine whether a job is PS data or
not.
Pattern3: includes most PS commands.
Pattern1: A small number of PS tags and headers
bit
4
Increase max number of the stored jobs.
Disabled (100)
Enabled (750)
Changes the maximum number of jobs that can be stored on the HDD. The default (disabled) is 100. If
this is enabled, the max. will be raised to 750.
bit
5
DFU
-
-
bit
6
Method for determining the image rotation for the edge to
bind on.
Disabled
Enabled
If enabled, the image rotation will be performed as they were in the specifications of older models for
the binding of pages of mixed orientation jobs.
The old models are below:
- PCL: Pre-04A models
- PS/PDF/RPCS:Pre-05S models
bit
7
Letterhead mode printing
Disabled
Enabled (Duplex)
Routes all pages through the duplex unit.