4.Service Tables
45
0: Manual TX and RX
operation
1: Memory TX and RX
operation (the display remains
the same)
Manual TX is not possible.
1: The display stays in standby mode even when the external handset is
used, so that other people can use the machine for memory TX operation.
Note that manual TX and RX are not possible with this setting.
Do not change these settings.
System Switch 0F (SP No. 1-101-016)
Country/area code for
functional settings (Hex)
This country/area code determines the factory settings of bit switches and
RAM addresses. However, it has no effect on the NCU parameter settings
and communication parameter RAM addresses.
Cross reference
NCU country code:
SP No. 2-103-001 for G3-1
SP No. 2-104-001 for G3-2
SP No. 2-105-001 for G3-3
System Switch 10 (SP No. 1-101-017)
To Next Page
Loading...
