Ricoh M0A0

4.Service Tables
67
memory to the format which was specified in the set-up protocol
(DIS/NSF) before transmission.
1-
5
Not used
Do not change the factory settings.
6-
7
Available unit of resolution in
which fax messages are received
For the best performance, do not change the factory settings.
The setting determined by these bits is informed to the transmitting terminal
in the pre-message protocol exchange (in the DIS/NSF frames).
Bit 7
Bit 6
Unit
0
0
mm
0
1
inch
1
0
mm and inch
1
1
Not used
Communication Switch 15 – Not used (do not change the settings)
Communication Switch 16 (SP No. 1-104-023)
No
Function
Comments
0
Not used
Do not change the settings.
1
Optional G3 unit (G3-2)
0: Not installed
1: Installed
Change this bit to 1 when installing the first optional G3 unit.
2
Not used
3
Select PSTN connection
0: Off
1: On
This switch enables the G3-2.
0: Off, no connection
1: Recognizes and enables G3-2.
This switch can be used only after G3-2 has been installed.
4-7
Not used
Do not change the settings.
Communication Switch 17 (SP No. 1-104-024)
No
Function
Comments
0
SEP reception
0: Disabled
1: Enabled
0: Polling transmission to another maker's machine using the SEP
(Selective Polling) signal is disabled.
1
SUB reception
0: Disabled
1: Enabled
0: Confidential reception to another maker's machine using the SUB
(Sub-address) signal is disabled.
2
PWD reception
0: Disabled
0: Disables features that require PWD (Password) signal reception.