Ricoh M0A0 - Page 730

4.Service Tables
104
Switch 03
No
FUNCTION
COMMENTS
available in transmit
mode
0: MH only
1: Disabled
transmission.
If the setting is "Disabled", the bit switch setting is used.
6-
7
ECM during transmission
Bit 7: 0, Bit 6: 0 = Off
Bit 7: 0, Bit 6: 1 = On
Bit 7: 1, Bit 6: 0 = Not
used
Bit 7: 1, Bit 6: 1 =
Disabled
For example, if ECM is switched on but is not wanted when sending to a particular
terminal, use the (0, 0) setting.
 V.8/V.34 protocol and JBIG compression are automatically disabled if
ECM is disabled.
 If the setting is "Disabled", the bit switch setting is used.
Switch 06 - Not used (Do not change the settings.)
Switch 07 - Not used (Do not change the settings.)
Switch 08 - Not used (Do not change the settings.)
Switch 09 - Not used (Do not change the settings.)
E-mail Parameters
The initial settings of the following e-mail parameters are all "0" (all parameters disabled).
Switch 00
No
FUNCTION
COMMENTS
0
MH Compression mode for e-mail
attachments
0: Off
1: On
Switches MH compression on and off for files attached to e-mails
for sending.
1
MR Compression mode for e-mail
attachments
0: Off
1: On
Switches MR compression on and off for files attached to e-mails
for sending.
2
MMR Compression mode for e-mail
attachments
0: Off
1: On
Switches MMR compression on and off for files attached to e-
mails for sending.
3-
6
Not used
Do not change these settings.
7
Designates the bits to reference for
The "0" selection (default) references the settings for Bits 00, 01,