CMU Software Update and Version Management
1100.4903.12 1.23 E-10
Back to... Close the current screen and go back to the software version
selection dialog to select a compatible software version.
Terminating the
software update:
After successful installation of each software version the CMU displays the
following screen:
Install next software... Go back to the software version selection dialog to
select additional software modules to be installed in
the same VersionManager session. This function
depends on the storage media and the number of
software installation versions available; see Table 1-1
on page 1.20.
Change disks Update the current screen after a change of the
storage medium.
Finish installation Close the VersionManager and reboot the CMU
(remove the external disk from the disk drive). The
installed firmware configurations are then operational.
The last configuration installed is taken as the active
configuration in the subsequent measurement
session.
Lack of disk space: Before installing the next software version, the CMU checks whether there is
enough disk space on the hard disk. If not, the following dialog is displayed:
To Next Page
Loading...
Need help?
General
