Configuration with the web interface
98-137654-A Chapter 6: Configuration 6-27
6666
Configuration
6.3.8.3 DNS setup
If you have access to a Domain Name Server (DNS) you can specify
the address of the e-mail server by using the server name instead of
its IP address. This can be used in Outgoing mail server in E-mail
setup on page 6-28.
You may statically specify the address of one or two DNS. Select the
DNS source as static and fill in IP address or addresses.
Alternatively, if your DHCP server can provide a DNS address and
you have selected DHCP client above, then select the same LAN as
your DNS source.
6.3.8.4 Gateway setup
If the ACU needs to communicate with network units outside the
specified sub-nets, you must specify a default gateway (typically a
router).
The default gateway can be set as a static IP address. Then set the
default gateway source to static and enter the IP address of the
default gateway. To remove the default gateway set it to 0.0.0.0.
Alternatively, if your DHCP server is able to provide a default
gateway address and you have selected DHCP client above, then
select the same LAN as your default gateway source.
6.3.8.5 Zeroconf Settings
On LAN ports 1,3 and 4 you can choose to add a zeroconf address in
the network (169.254.0.0/24).This zeroconf address will be in
addition to the existing static or DHCP IP address. One port at a time
can be enabled.
Zeroconf allows devices to connect to a network automatically.
SAILOR100TM.book Page 27 Tuesday, January 29, 2013 2:44 PM
To Next Page
