Removal and replacement of ADU modules
98-137654-A Chapter 8: Service & maintenance 8-45
8888
Service & maintenance
8. Loosen the 4x4 mm Allen screws (thread size M5) of the motor
assembly.
9. Lift the complete Cross Elevation Motor & Encoder assembly free,
in the key holes, from the pedestal and remove it.
Figure 8-51: X-Elevation Motor & Encoder — belt tension/adjustment screw
Figure 8-52: Cross Elevation motor assembly, 4 Allen screws
SAILOR100TM.book Page 45 Tuesday, January 29, 2013 2:44 PM
To Next Page
