Installation check list: ACU, connectors and wiring
7-4 Chapter 7: Installation check 98-137654-A
10.
Measure that the power has the correct
polarity in the power connector, before
connecting it to the ACU power input.
(Vin+: left, Vin-: right).
Use a volt meter. See
Table 4-1: DC Input plug,
outline and pin
assignment on page 4-2.
Step Task
Verification and further
information
Done
Table 7-2: Installation check list: ACU, connectors and wiring (Continued)
SAILOR100TM.book Page 4 Tuesday, January 29, 2013 2:44 PM
To Next Page
