Calibration of the SAILOR 100 Satellite TV
98-137654-A Chapter 6: Configuration 6-7
6666
Configuration
The following table shows the error codes that might be displayed
during a calibration.
The SAILOR 100 Satellite TV is calibrated now. If the calibration
failed there will be a message on the calibration screen.
Error code Explanation
1 The elevation of the selected satellite is too low. Select
another satellite.
2 The elevation of the selected satellite is too high. Select
another satellite.
4 The calibration values could not be saved. Possibly due to
defective hardware.
5 The antenna could not point with sufficient precision. Check
that the antenna is mounted in a stable way. Other possible
causes might be electrical or mechanical faults.
6 No signal received. Check that there is free line of sight. Try
again or try with another satellite.
7 RF setup error.
8 Invalid satellite, e.g. satellite not visible.
Table 6-3: Possible error codes during calibration
SAILOR100TM.book Page 7 Tuesday, January 29, 2013 2:44 PM
To Next Page
Loading...
