SMC Networks TigerStack II SMC8848M

24-1
C HAPTER 24
I NTERFACE C OMMANDS
These commands are used to display or set communication parameters for
an Ethernet port, aggregated link, or VLAN.
Table 24-1 Interface Commands
Command Function Mode Page
interface Configures an interface type and enters
interface configuration mode
GC 24-2
description Adds a description to an interface
configuration
IC 24-3
speed-duplex Configures the speed and duplex
operation of a given interface when
autonegotiation is disabled
IC 24-3
negotiation Enables autonegotiation of a given
interface
IC 24-5
capabilities Advertises the capabilities of a given
interface for use in autonegotiation
IC 24-6
flowcontrol Enables flow control on a given
interface
IC 24-7
media-type Force port type selected for
combination ports
IC 24-8
shutdown Disables an interface IC 24-9
switchport broadcast
packet-rate
Configures the broadcast storm
control threshold
IC 24-10
clear counters Clears statistics on an interface PE 24-11
show interfaces status Displays status for the specified
interface
NE, PE 24-12