IP F
ILTER
C
OMMANDS
22-49
Command Usage
• If anyone tries to access a management interface on the switch from
an invalid address, the switch will reject the connection, enter an event
message in the system log, and send a trap message to the trap
manager.
• IP address can be configured for SNMP, web and Telnet access
respectively. Each of these groups can include up to five different sets
of addresses, either individual addresses or address ranges.
• When entering addresses for the same group (i.e., SNMP, web or
Telnet), the switch will not accept overlapping address ranges. When
entering addresses for different groups, the switch will accept
overlapping address ranges.
• You cannot delete an individual address from a specified range. You
must delete the entire range, and reenter the addresses.
• You can delete an address range just by specifying the start address, or
by specifying both the start address and end address.
Example
This example restricts management access to the indicated addresses.
show management
This command displays the client IP addresses that are allowed
management access to the switch through various protocols.
Syntax
show management {all-client | http-client | snmp-client |
telnet-client}
• all-client - Adds IP address(es) to the SNMP, web and Telnet
groups.
• http-client - Adds IP address(es) to the web group.
• snmp-client - Adds IP address(es) to the SNMP group.
• telnet-client - Adds IP address(es) to the Telnet group.
Console(config)#management all-client 192.168.1.19
Console(config)#management all-client 192.168.1.25 192.168.1.30
Console#
To Next Page
Loading...
Need help?
General
