SMC Networks TigerStack II SMC8848M User Manual

P RIORITY C OMMANDS (L AYER 3 AND 4)
31-13
Example
The following example shows how to enable IP DSCP mapping globally:
map ip dscp (Interface Configuration)
This command sets IP DSCP priority (i.e., Differentiated Services Code
Point priority). Use the no form to restore the default table.
Syntax
map ip dscp dscp-value cos cos-value
no map ip dscp
• dscp-value - 8-bit DSCP value. (Range: 0-63)
• cos-value - Class-of-Service value (Range: 0-7)
Default Setting
The DSCP default values are defined in the following table. Note that
all the DSCP values that are not specified are mapped to CoS value 0.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#map ip dscp
Console(config)#
Table 31-6 Mapping IP DSCP to CoS Values
IP DSCP Value CoS Value
00
81
10, 12, 14, 16 2
18, 20, 22, 24 3
26, 28, 30, 32, 34, 36 4
38, 40, 42 5
48 6
46, 56 7

SMC Networks TigerStack II SMC8848M Specifications

General

Brand	SMC Networks
Model	TigerStack II SMC8848M
Category	Switch
Language	English