S
YSTEM
M
ANAGEMENT
C
OMMANDS
20-52
clock timezone
This command sets the time zone for the switch’s internal clock.
Syntax
clock timezone name hour hours minute minutes {before-utc |
after-utc}
• name - Name of timezone, usually an acronym. (Range: 1-29
characters)
• hours - Number of hours before/after UTC. (Range: 0-13 hours)
• minutes - Number of minutes before/after UTC. (Range: 0-59
minutes)
• before-utc - Sets the local time zone before (east) of UTC.
• after-utc - Sets the local time zone after (west) of UTC.
Default Setting
None
Command Mode
Global Configuration
Command Usage
This command sets the local time zone relative to the Coordinated
Universal Time (UTC, formerly Greenwich Mean Time or GMT),
based on the earth’s prime meridian, zero degrees longitude. To display
a time corresponding to your local time, you must indicate the number
of hours and minutes your time zone is east (before) or west (after) of
UTC.
Example
Related Commands
show sntp (20-51)
Console(config)#clock timezone Japan hours 8 minute 0 after-UTC
Console(config)#
To Next Page
Loading...
Need help?
General
