DHCP C
OMMANDS
35-12
Command Mode
DHCP Pool Configuration
Usage Guidelines
• If DNS IP servers are not configured for a DHCP client, the client
cannot correlate host names to IP addresses.
• Servers are listed in order of preference (starting with address1 as the
most preferred server).
Example
next-server
This command configures the next server in the boot process of a DHCP
client. Use the no form to remove the boot server list.
Syntax
[no] next-server address
address - Specifies the IP address of the next server in the boot
process, which is typically a Trivial File Transfer Protocol (TFTP)
server.
Default Setting
None
Command Mode
DHCP Pool Configuration
Example
Related Commands
bootfile (35-13)
Console(config-dhcp)#dns-server 10.1.1.253 192.168.3.19
Console(config-dhcp)#
Console(config-dhcp)#next-server 10.1.0.21
Console(config-dhcp)#
To Next Page
Loading...
Need help?
General
