SMC Networks TigerStack II SMC8848M

DHCP C OMMANDS
35-2
DHCP Client
ip dhcp client-identifier
This command specifies the DCHP client identifier for the current
interface. Use the no form to remove this identifier.
Syntax
ip dhcp client-identifier {text text | hex hex}
no ip dhcp client-identifier
• text - A text string. (Range: 1-15 characters)
• hex - The hexadecimal value.
Default Setting
None
Command Mode
Interface Configuration (VLAN)
Command Usage
This command is used to include a client identifier in all
communications with the DHCP server. The identifier type depends on
the requirements of your DHCP server.
Example
Related Commands
ip dhcp restart client (35-3)
Table 35-2 DHCP Client Commands
Command Function Mode Page
ip dhcp
client-identifier
Specifies the DHCP client identifier for this
switch
IC 35-2
ip dhcp restart client Submits a BOOTP or DHCP client request PE 35-3
Console(config)#interface vlan 2
Console(config-if)#ip dhcp client-identifier hex 00-00-e8-66-65-72
Console(config-if)#