SMC Networks TigerStack II SMC8848M

S YSTEM M ANAGEMENT C OMMANDS
20-18
dir
This command displays a list of files in flash memory.
Syntax
dir [unit:] {{boot-rom: | config: | opcode:} [filename]}
The type of file or image to display includes:
• boot-rom
- Boot ROM (or diagnostic) image file.
• config - Switch configuration file.
• opcode - Run-time operation code image file.
• filename - Name of configuration file or code image. If this file exists
but contains errors, information on this file cannot be shown.
• unit - Stack unit. (Range: 1-8)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• If you enter the command dir without any parameters, the system
displays all files.
• A colon (:) is required after the specified unit number.
• File information is shown below:
Table 20-6 File Directory Information
Column Heading Description
file name The name of the file.
file type File types: Boot-Rom, Operation Code, and Config
file.
startup Shows if this file is used when the system is started.
size The length of the file in bytes.