SMC Networks TigerStack II SMC8848M User Manual

35-1
C HAPTER 35
DHCP C OMMANDS
These commands are used to configure Dynamic Host Configuration
Protocol (DHCP) client, relay, and server functions. You can configure any
VLAN interface to be automatically assigned an IP address via DHCP.
This switch can be configured to relay DHCP client configuration requests
to a DHCP server on another network, or you can configure this switch to
provide DHCP service directly to any client.
Table 35-1 DHCP Commands
Command Group Function Page
DHCP Client Allows interfaces to dynamically acquire IP address
information
35-2
DHCP Relay Relays DHCP requests from local hosts to a remote
DHCP server
35-4
DHCP Server Configures DHCP service using address pools or
static bindings
35-6

SMC Networks TigerStack II SMC8848M Specifications

General

Brand	SMC Networks
Model	TigerStack II SMC8848M
Category	Switch
Language	English