SMC Networks TigerStack II SMC8848M User Manual

L AYER 3/4 P RIORITY S ETTINGS
12-15
Click Priority, IP Port Priority. Enter the port number for a network
application in the IP Port Number box and the new CoS value in the Class
of Service box, and then click Apply.
Figure 12-9 IP Port Priority
CLI – The following example globally enables IP Port Priority service on
the switch, maps HTTP traffic (on port 1) to CoS value 0, and then
displays the IP Port Priority settings.
* Mapping specific values for IP Port Priority is implemented as an interface config-
uration command, but any changes will apply to the all interfaces on the switch.
Console(config)#map ip port 31-9
Console(config)#interface ethernet 1/1 24-2
Console(config-if)#map ip port 80 cos 0 31-10
Console(config-if)#end
Console#show map ip port ethernet 1/5 31-14
TCP port mapping status: disabled
Port Port no. COS
--------- -------- ---
Eth 1/ 1 80 0
Console#

SMC Networks TigerStack II SMC8848M Specifications

General

Device Type	Switch
Manageable	Yes
Stackable	Yes
Switching Capacity	17.6 Gbps
Forwarding Rate	13.1 Mpps
MAC Address Table Size	8K entries
Jumbo Frame Support	Yes
Form Factor	Rack-mountable
Uplink Ports	4 x Gigabit SFP
Layer	2
Power Supply	100-240V AC, 50-60Hz
Dimensions	17.3 x 1.7 in
Operating Temperature	0°C to 40°C
Storage Temperature	-4 °F to 158 °F (-20 °C to 70 °C)
Humidity	10% to 90% (non-condensing)

Summary

SECTION I GETTING STARTED

Chapter 1 Introduction

Provides an overview of the switch and basic concepts about network switches.

Chapter 2 Initial Configuration

Describes the basic settings required to access the management interface.

SECTION II SWITCH MANAGEMENT

Chapter 3 Configuring the Switch

Describes how to configure the switch via a web browser and Command Line Interface.

Chapter 4 Basic Management Tasks

Covers basic functions for management access, displaying and upgrading software, or resetting the system.

SECTION III COMMAND LINE INTERFACE

Chapter 18 Overview of the Command Line Interface

Explains how to use the Command Line Interface (CLI) for switch management.

Chapter 19 General Commands

Details commands for controlling command access mode, configuration, and other basic functions.

SECTION IV APPENDICES

Software Specifications

Details software features, management features, and supported standards.

Troubleshooting

Provides common symptoms and actions for problems accessing the management interface.

Glossary

Provides definitions of terms used throughout the manual.