SMC Networks TigerStack II SMC8848M

VLAN C ONFIGURATION
11-16
belonging to the port’s default VLAN (i.e., associated with the PVID)
are also transmitted as tagged frames.
- Hybrid – Specifies a hybrid VLAN interface. The port may transmit
tagged or untagged frames.
• Trunk Member – Indicates if a port is a member of a trunk. To add a
trunk to the selected VLAN, use the last table on the VLAN Static Table
page.
Web – Click VLAN, 802.1Q VLAN, Port Configuration or Trunk
Configuration. Fill in the required settings for each interface, click Apply.
Figure 11-7 VLAN Port Configuration
CLI – This example sets port 3 to accept only tagged frames, assigns
PVID 3 as the native VLAN ID, enables GVRP, sets the GARP timers,
and then sets the switchport mode to hybrid.
Console(config)#interface ethernet 1/3 24-2
Console(config-if)#switchport acceptable-frame-types tagged 30-11
Console(config-if)#switchport ingress-filtering 30-12
Console(config-if)#switchport native vlan 3 30-13
Console(config-if)#switchport gvrp 30-4
Console(config-if)#garp timer join 20 30-5
Console(config-if)#garp timer leave 90
Console(config-if)#garp timer leaveall 2000
Console(config-if)#switchport mode hybrid 30-10
Console(config-if)#