SMC Networks TigerStack II SMC8848M

C ONFIGURING THE R OUTING I NFORMATION P ROTOCOL
17-33
Web - Click Routing Protocol, RIP, General Settings. Enable or disable
RIP, set the RIP version used on previously unset interfaces to RIPv1 or
RIPv2, set the basic update timer, and then click Apply.
Figure 17-14 RIP General Settings
CLI - This example sets the router to use RIP Version 2, and sets the basic
timer to 15 seconds.
Console(config)#router rip 37-9
Console(config-router)#version 2 37-15
Console(config-router)#timers basic 15 37-11
Console(config-router)#end
Console#show rip globals 37-22
RIP Process: Enabled
Update Time in Seconds: 15
Number of Route Change: 0
Number of Queries: 1
Console#