SMC Networks TigerStack II SMC8848M

A CCESS C ONTROL L IST C OMMANDS
23-16
show ipv6 access-group
This command shows the ports assigned to IPv6 ACLs.
Command Mode
Privileged Exec
Example
Related Commands
ipv6 access-group (23-15)
MAC ACLs
The commands in this section configure ACLs based on hardware
addresses, packet format, and Ethernet type. To configure MAC ACLs,
first create an access list containing the required permit or deny rules, and
then bind the access list to one or more ports
Console#show ip access-group
Interface ethernet 1/2
IPv6 standard access-list david in
Console#
Table 23-4 MAC ACL Commands
Command Function Mode Page
access-list mac Creates a MAC ACL and enters
configuration mode
GC 23-17
permit, deny Filters packets matching a specified
source and destination address,
packet format, and Ethernet type
MAC-ACL 23-18
show mac access-list Displays the rules for configured
MAC ACLs
PE 23-20
mac access-group Adds a port to a MAC ACL IC 23-20
show mac
access-group
Shows port assignments for MAC
ACLs
PE 23-21