IP R
OUTING
C
OMMANDS
37-22
show rip globals
This command displays global configuration settings for RIP.
Command Mode
Privileged Exec
Example
show ip rip
This command displays information about interfaces configured for RIP.
Syntax
show ip rip {configuration | status | peer}
• configuration - Shows RIP configuration settings for each
interface.
• status - Shows the status of routing messages on each interface.
• peer - Shows information on neighboring routers, along with
information about the last time a route update was received, the RIP
version used by the neighbor, and the status of routing messages
received from this neighbor.
Console#show rip globals
RIP Process: Enabled
Update Time in Seconds: 30
Number of Route Change: 0
Number of Queries: 1
Console#
Table 37-6 show rip globals - display description
Field Description
RIP Process Indicates if RIP has been enabled or disabled.
Update Time in Seconds The interval at which RIP advertises known route
information. (Default: 30 seconds)
Number of Route
Changes
Number of times routing information has changed.
Number of Queries Number of router database queries received by this
router.
To Next Page
Loading...
Need help?
General
