SMC Networks TigerStack II SMC8848M

I NTERFACE C OMMANDS
24-2
interface
This command configures an interface type and enter interface
configuration mode. Use the no form to remove a trunk.
Syntax
interface interface
no interface port-channel channel-id
• interface
• ethernet unit/port
- unit - Stack unit. (Range: 1-8)
- port - Port number. (Range: 1-26/50)
• port-channel channel-id (Range: 1-32)
• vlan vlan-id (Range: 1-4093)
Default Setting
None
Command Mode
Global Configuration
Example
To specify port 4, enter the following command:
show interfaces
counters
Displays statistics for the specified
interfaces
NE, PE 24-13
show interfaces
switchport
Displays the administrative and
operational status of an interface
NE, PE 24-15
Console(config)#interface ethernet 1/4
Console(config-if)#
Table 24-1 Interface Commands (Continued)
Command Function Mode Page