SMC Networks TigerStack II SMC8848M User Manual

U SER A UTHENTICATION C OMMANDS
22-20
Telnet Server Commands
This section describes commands used to configure Telnet management
access to the switch.
ip telnet server
This command allows this device to be monitored or configured from
Telnet. It also specifies the TCP port number used by the Telnet interface.
Use the no form without the “port” keyword to disable this function. Use
the no from with the “port” keyword to use the default port.
Syntax
ip telnet server [port port-number]
no telnet server [port]
• port - The TCP port used by the Telnet interface.
• port-number - The TCP port number to be used by the browser
interface. (Range: 1-65535)
Default Setting
•Server: Enabled
• Server Port: 23
Command Mode
Global Configuration
Example
Table 22-9 Telnet Server Commands
Command Function Mode Page
ip telnet server Allows the switch to be monitored or
configured from Telnet; also specifies the
port to be used by the Telnet interface
GC 22-16
Console(config)#ip telnet server
Console(config)#ip telnet port 123
Console(config)#

SMC Networks TigerStack II SMC8848M Specifications

General

Device Type	Switch
Manageable	Yes
Stackable	Yes
Switching Capacity	17.6 Gbps
Forwarding Rate	13.1 Mpps
MAC Address Table Size	8K entries
Jumbo Frame Support	Yes
Form Factor	Rack-mountable
Uplink Ports	4 x Gigabit SFP
Layer	2
Power Supply	100-240V AC, 50-60Hz
Dimensions	17.3 x 1.7 in
Operating Temperature	0°C to 40°C
Storage Temperature	-4 °F to 158 °F (-20 °C to 70 °C)
Humidity	10% to 90% (non-condensing)

Summary

SECTION I GETTING STARTED

Chapter 1 Introduction

Provides an overview of the switch and basic concepts about network switches.

Chapter 2 Initial Configuration

Describes the basic settings required to access the management interface.

SECTION II SWITCH MANAGEMENT

Chapter 3 Configuring the Switch

Describes how to configure the switch via a web browser and Command Line Interface.

Chapter 4 Basic Management Tasks

Covers basic functions for management access, displaying and upgrading software, or resetting the system.

SECTION III COMMAND LINE INTERFACE

Chapter 18 Overview of the Command Line Interface

Explains how to use the Command Line Interface (CLI) for switch management.

Chapter 19 General Commands

Details commands for controlling command access mode, configuration, and other basic functions.

SECTION IV APPENDICES

Software Specifications

Details software features, management features, and supported standards.

Troubleshooting

Provides common symptoms and actions for problems accessing the management interface.

Glossary

Provides definitions of terms used throughout the manual.