P
RIORITY
C
OMMANDS
(L
AYER
3
AND
4)
31-9
map ip port (Global Configuration)
This command enables IP port mapping (i.e., class of service mapping for
TCP/UDP sockets). Use the no form to disable IP port mapping.
Syntax
[no] map ip port
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The precedence for priority mapping is IP Port, IP Precedence or IP
DSCP, and default switchport priority.
Example
The following example shows how to enable TCP/UDP port mapping
globally:
map ip precedence Maps IP precedence value to a class of
service
IC 31-11
map ip dscp Enables IP DSCP class of service
mapping
GC 31-12
map ip dscp Maps IP DSCP value to a class of service IC 31-13
show map ip port Shows the IP port map PE 31-14
show map ip
precedence
Shows the IP precedence map PE 31-15
show map ip dscp Shows the IP DSCP map PE 31-16
Console(config)#map ip port
Console(config)#
Table 31-4 Priority Commands (Layer 3 and 4)
Command Function Mode Page
To Next Page
Loading...
Need help?
General
