IP R
OUTING
17-28
Displaying the Routing Table
You can display all the routes that can be accessed via the local network
interfaces, via static routes, or via a dynamically learned route. If route
information is available through more than one of these methods, the
priority for route selection is local, static, and then dynamic. Also note that
the route for a local interface is not enabled (i.e., listed in the routing table)
unless there is at least one active link connected to that interface.
Command Attributes
• Interface – Index number of the IP interface.
• IP Address – IP address of the destination network, subnetwork, or
host. Note that the address 0.0.0.0 indicates the default gateway for this
router.
• Netmask – Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific subnets.
• Next Hop – The IP address of the next hop (or gateway) in this route.
• Protocol – The protocol which generated this route information.
(Options: local, static, RIP)
• Metric – Cost for this interface.
• Entry Count – The number of table entries.
To Next Page
Loading...
