A
CCESS
C
ONTROL
L
IST
C
OMMANDS
23-18
permit, deny (MAC ACL)
This command adds a rule to a MAC ACL. The rule filters packets
matching a specified MAC source or destination address (i.e., physical layer
address), or Ethernet protocol type. Use the no form to remove a rule.
Syntax
[no]
{
permit
|
deny
}
{
any
|
host
source
|
source address-bitmask
}
{
any
|
host
destination
|
destination address-bitmask
}
[
vid
vid vid-bitmask
] [
ethertype
protocol
[
protocol
-
bitmask
]]
Note:- The default is for Ethernet II packets.
[no]
{
permit
|
deny
}
tagged-eth2
{
any
|
host
source
|
source address-bitmask
}
{
any
|
host
destination
|
destination address-bitmask
}
[
vid
vid vid-bitmask
] [
ethertype
protocol
[
protocol
-
bitmask
]]
[no]
{
permit
|
deny
}
untagged-eth2
{
any
|
host
source
|
source address-bitmask
}
{
any
|
host
destination
|
destination address-bitmask
}
[
ethertype
protocol
[
protocol
-
bitmask
]]
[no]
{
permit
|
deny
}
tagged-802.3
{
any
|
host
source
|
source address-bitmask
}
{
any
|
host
destination
|
destination address-bitmask
}
[
vid
vid vid-bitmask
]
[no]
{
permit
|
deny
}
untagged-802.3
{
any
|
host
source
|
source address-bitmask
}
{
any
|
host
destination
|
destination address-bitmask
}
• tagged-eth2 – Tagged Ethernet II packets.
• untagged-eth2 – Untagged Ethernet II packets.
• tagged-802.3 – Tagged Ethernet 802.3 packets.
• untagged-802.3 – Untagged Ethernet 802.3 packets.
• any – Any MAC source or destination address.
• host – A specific MAC address.
To Next Page
Loading...
