IP I
NTERFACE
C
OMMANDS
36-20
Related Commands
ipv6 address autoconfig (36-16)
show ipv6 interface (36-22)
ipv6 address link-local
This command configures an IPv6 link-local address for an interface and
enables IPv6 on the interface. Use the no form without any arguments to
remove all manually configured IPv6 addresses from the interface. Use the
no form with a specific address to remove it from the interface.
Syntax
ipv6 address ipv6-address link-local
no ipv6 address [ipv6-address link-local]
ipv6-address - The IPv6 address assigned to the interface. The
address must be formatted according to RFC 2373 “IPv6
Addressing Architecture,” using 8 colon-separated 16-bit
hexadecimal values. One double colon may be used in the address
to indicate the appropriate number of zeros required to fill the
undefined fields. And the address prefix must be FE80.
Default Setting
No IPv6 addresses are defined
Command Mode
Interface Configuration (VLAN)
Command Usage
• The address specified with this command replaces a link-local address
that was automatically generated for the interface.
• You can configure multiple IPv6 global unicast addresses per
interface, but only one link-local address per interface.
• If a duplicate address is detected, a warning message is sent to the
console.
To Next Page
Loading...
Need help?
General
