SMC Networks TigerStack II SMC8848M

IGMP S NOOPING C OMMANDS
33-3
ip igmp snooping vlan static
This command adds a port to a multicast group. Use the no form to
remove the port.
Syntax
[no] ip igmp snooping vlan vlan-id static ip-address interface
• vlan-id - VLAN ID (Range: 1-4093)
• ip-address - IP address for multicast group
• interface
• ethernet unit/port
- unit - Stack unit. (Range: 1-8)
- port - Port number. (Range: 1-26/50)
• port-channel channel-id (Range: 1-32)
Default Setting
None
Command Mode
Global Configuration
Example
The following shows how to statically configure a multicast group on a
port:
ip igmp snooping version
This command configures the IGMP snooping version. Use the no form
to restore the default.
Syntax
ip igmp snooping version {1 | 2}
no ip igmp snooping version
• 1 - IGMP Version 1
• 2 - IGMP Version 2
Console(config)#ip igmp snooping vlan 1 static 224.0.0.12 ethernet
1/5
Console(config)#