SMC Networks TigerStack II SMC8848M

C LASS OF S ERVICE C OMMANDS
31-8
show queue cos-map
This command shows the class of service priority map.
Syntax
show queue cos-map [interface]
interface
• ethernet unit/port
- unit - Stack unit. (Range: 1-8)
- port - Port number. (Range: 1-26/50)
• port-channel channel-id (Range: 1-32)
Default Setting
None
Command Mode
Privileged Exec
Example
Priority Commands (Layer 3 and 4)
This section describes commands used to configure Layer 3 and Layer 4
traffic priority on the switch.
Console#show queue cos-map ethernet 1/1
Information of Eth 1/1
CoS Value: 0 1 2 3 4 5 6 7
Priority Queue: 2 0 1 3 4 5 6 7
Console#
Table 31-4 Priority Commands (Layer 3 and 4)
Command Function Mode Page
map ip port Enables TCP/UDP class of service
mapping
GC 31-9
map ip port Maps TCP/UDP socket to a class of
service
IC 31-10
map ip precedence Enables IP precedence class of service
mapping
GC 31-10