SMC Networks TigerStack II SMC8848M

C ONSOLE P ORT S ETTINGS
4-37
device connected to the serial port. (Range: 9600, 19200, 38400, 57600,
or 115200 baud, Auto; Default: Auto)
• Stop Bits – Sets the number of the stop bits transmitted per byte.
(Range:1-2;Default: 1 stop bit)
• Password
1
– Specifies a password for the line connection. When a
connection is started on a line with password protection, the system
prompts for the password. If you enter the correct password, the system
shows a prompt. (Default: No password)
• Login
1
– Enables password checking at login. You can select
authentication by a single global password as configured for the
Password parameter, or by passwords set up for specific user-name
accounts. (Default: Local)
Web – Click System, Line, Console. Specify the console port connection
parameters as required, then click Apply.
Figure 4-16 Configuring the Console Port
1. CLI only.