SMC Networks TigerStack II SMC8848M

SNMP - SERVER ENABLE TRAPS
21-9
user command. Otherwise, the authentication password and/or
privacy password will not exist, and the switch will not authorize
SNMP access for the host. However, if you specify a V3 host with the
“noauth” option, an SNMP user account will be generated, and the
switch will authorize SNMP access for the host.
Example
Related Commands
snmp-server enable traps (21-9)
snmp-server enable traps
This command enables this device to send Simple Network Management
Protocol traps or informs (i.e., SNMP notifications). Use the no form to
disable SNMP notifications.
Syntax
[no] snmp-server enable traps [authentication | link-up-down]
• authentication - Keyword to issue authentication failure
notifications.
• link-up-down - Keyword to issue link-up or link-down
notifications.
Default Setting
Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Command Usage
• If you do not enter an snmp-server enable traps command, no
notifications controlled by this command are sent. In order to
configure this device to send SNMP notifications, you must enter at
least one snmp-server enable traps command. If you enter the
command with no keywords, both authentication and link-up-down
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#