SMC Networks TigerStack II SMC8848M

P RIORITY C OMMANDS (L AYER 3 AND 4)
31-11
Command Mode
Global Configuration
• Command Usage
• The precedence for priority mapping is IP Port, IP Precedence or IP
DSCP, and default switchport priority.
• IP Precedence and IP DSCP cannot both be enabled. Enabling one of
these priority types will automatically disable the other type.
Example
The following example shows how to enable IP precedence mapping
globally:
map ip precedence (Interface Configuration)
This command sets IP precedence priority (i.e., IP Type of Service
priority). Use the no form to restore the default table.
Syntax
map ip precedence ip-precedence-value cos cos-value
no map ip precedence
• precedence-value - 3-bit precedence value. (Range: 0-7)
• cos-value - Class-of-Service value (Range: 0-7)
Default Setting
The list below shows the default priority mapping.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#map ip precedence
Console(config)#
Table 31-5 Mapping IP Precedence to CoS Values
IP Precedence Value 01234567
CoS Value 01234567