SMC Networks TigerStack II SMC8848M

DHCP S ERVER
35-17
is used (see page 4-253). This command is valid for manual bindings
only.
•The no host command only clears the address from the DHCP server
database. It does not cancel the IP address currently in use by the host.
Example
Related Commands
client-identifier (35-17)
hardware-address (35-18)
client-identifier
This command specifies the client identifier of a DHCP client. Use the no
form to remove the client identifier.
Syntax
client-identifier {text text | hex hex}
no client-identifier
• text - A text string. (Range: 1-15 characters)
• hex - The hexadecimal value.
Default Setting
None
Command Mode
DHCP Pool Configuration
Command Usage
• This command identifies a DHCP client to bind to an address
specified in the host command. If both a client identifier and hardware
address are configured for a host address, the client identifier takes
precedence over the hardware address in the search procedure.
• BOOTP clients cannot transmit a client identifier. To bind an address
to a BOOTP client, you must associate a hardware address with the
host entry.
Console(config-dhcp)#host 10.1.0.21 255.255.255.0
Console(config-dhcp)#