U
SER
A
UTHENTICATION
C
OMMANDS
22-2
User Account Commands
The basic commands required for management access are listed in this
section. This switch also includes other options for password checking via
the console or a Telnet connection (page 20-21), user authentication via a
remote authentication server (page 22-1), and host access authentication
for specific ports (page 22-37).
username
This command adds named users, requires authentication at login,
specifies or changes a user's password (or specify that no password is
required), or specifies or changes a user's access level. Use the no form to
remove a user name.
Syntax
username name {access-level level | nopassword |
password {0 | 7} password}
no username name
• name - The name of the user.
(Maximum length: 8 characters, case sensitive. Maximum users: 16)
• access-level level - Specifies the user level.
The device has two predefined privilege levels:
0: Normal Exec, 15:Privileged Exec.
• nopassword - No password is required for this user to log in.
•{0 | 7} - 0 means plain password, 7 means encrypted password.
Table 22-2 User Access Commands
Command Function Mode Page
username Establishes a user name-based authentication
system at login
GC 22-2
enable password Sets a password to control access to the
Privileged Exec level
GC 22-4
To Next Page
Loading...
Need help?
General
