C
ONFIGURING
VLAN I
NTERFACES
30-13
switchport native vlan
This command configures the PVID (i.e., default VLAN ID) for a port.
Use the no form to restore the default.
Syntax
switchport native vlan vlan-id
no switchport native vlan
vlan-id - Default VLAN ID for a port. (Range: 1-4093, no leading
zeroes)
Default Setting
VLAN 1
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• If an interface is not a member of VLAN 1 and you assign its PVID
to this VLAN, the interface will automatically be added to VLAN 1 as
an untagged member. For all other VLANs, an interface must first be
configured as an untagged member before you can assign its PVID to
that group.
• If acceptable frame types is set to all or switchport mode is set to
hybrid, the PVID will be inserted into all untagged frames entering
the ingress port.
Example
The following example shows how to set the PVID for port 1 to VLAN 3:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport native vlan 3
Console(config-if)#
To Next Page
Loading...
Need help?
General
