SMC Networks TigerStack II SMC8848M

S PANNING T REE C OMMANDS
29-24
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This command defines the priority for the use of an interface in the
multiple spanning-tree. If the path cost for all interfaces on a switch are
the same, the interface with the highest priority (that is, lowest value)
will be configured as an active link in the spanning tree.
Where more than one interface is assigned the highest priority, the
interface with lowest numeric identifier will be enabled.
Example
Related Commands
spanning-tree mst cost (29-22)
spanning-tree protocol-migration
This command re-checks the appropriate BPDU format to send on the
selected interface.
Syntax
spanning-tree protocol-migration interface
interface
• ethernet unit/port
- unit - Stack unit. (Range: 1-8)
- port - Port number. (Range: 1-26/50)
• port-channel channel-id (Range: 1-32)
Command Mode
Privileged Exec
Console(config)#interface ethernet ethernet 1/5
Console(config-if)#spanning-tree mst 1 port-priority 0
Console(config-if)#