STUDER 21. Sep. 2004 Release Notes Vista 3.4
17/18
(blue / black) shown in black, other are shown in blue – same
as titles in “Open Title” menu
CLEAR HELD without timecode running didn't
switch the held status off
Fixed.
WRITE TO NEXT CHANGE was sometimes missing
last value by one. (e.g. pan recorded to 0,
replayed at 1L)
Fixed.
Protected Patch points could get lost when using
dynamic automation
Fixed.
D950: Instability when changing automation
state of MUTE button on CAS
Fixed.
When tape stopped without having written a
pass, options selected to be cleared at end of
pass were cleared
Now this option is only valid, if a pass has been
really written. If tape is stopped without any
objects being written, there is no clearing of
options performed. This means that in a lot of
cases the option “End Of Pass Clears… Held
Objects” is ok to be deactivated. Typically the
user runs a try without writing anything. Since
this is not regarded as a mix pass, there is no
clearing taking place anyway. *
*
To Next Page
Loading...
