STUDER 21. Sep. 2004 Release Notes Vista 3.4
16/18
Minor improvements and fixed bugs
Description Comment
Various:
Label type in menu "Subclassify Digital
Interfaces" in menu SysAdmin/General Patch
shows only fixed labels
Label type now follows label type selected in
General Patch
It is now possible to SOLO master channels Any freshly generated configuration will have
this feature in. In order to add this feature to
existing configurations, add the ON/OFF function
to the SOLO bus within existing configurations in
the Configuration Editor software and re-
generate the configuration. However, in some
cases it is possible that configurations will need
more DSP cards.
When applying monitor settings within setup
menu, these settings were not remembered the
next time the title was loaded
Changed name of button into "Apply for session
only" in order to make clear that this button
doesn't save the settings, but only applies them
as long as the title isn't closed.
Instability when scrolling past last
section/screen
Fixed
Mic Preamp gains were sometimes not displayed
correctly after a title change – until recalling a
snapshot (sometimes twice necessary)
Fixed.
Digital meter peak values don't update after a
while
Fixed.
Unnecessary logfile entry "Stallion not present"
on Vista consoles
Fixed.
When booting the DSP core without MemNet
connection, the last state was not always
restored when working with large configurations
Fixed when recompiling configuration with
Configuration Editor 3.4
Sometimes after loading user preferences, the
D950 DESK icon would appear on the toolbar
Fixed. Doesn't appear anymore.
When changing the "Momentary Activation Time"
in the VISTA SETTINGS menu, this would make
the console not recognizing fast repeated button
presses anymore (e.g. MUTEs).
Fixed.
Instability when pasting strips multiple times
after each other in strip setup window
Fixed.
GPIO events were sometimes lost, especially
when working the D19m RCC card GPIOs
Fixed.
When copying parameters between channels,
not 100% all parameters were copied (e.g. the
dynamics did not include “look forward time”)
Fixed.
It was not possible, to put a reverb channel
setting into the clipboard library
By using “copy pan” or “copy all” this is now
possible.
Static Automation:
D950: Bus assigns were not protected together
with channel
Fixed.
Dynamic Automation:
Separate icon in toolbar for opening AutoTouch+
panel
If mix options file was write protected and user
wanted to overwrite file, it seemed like it
succeeded.
Warning added, if user tries to save options to a
write protected file.
TRIM TO END sometimes didn't work Fixed
Loading mix options was showing wrong colours Fixed. The currently loaded mix options are
To Next Page
Loading...
