Vista Digital Mixing System
Date printed: 20.08.09 SW V4.1 Software V4.1 17
• Setup with the OnAir configuration tool also on the Vista side.
A.5.8 IP Addresses
The IP addresses of the SCore Live bridge cards should not be changed.
They are always set to 192.168.1.60 for the primary network port, and to
192.168.2.60 for the secondary network port.
Please refer to chapter 9 for network examples with Vista and OnAir
consoles in a RELINK setup.
Note: In case of a network design where more than one Vista console communi-
cates with its SCore through one and the same Ethernet switch, the IP ad-
dresses may be changed as with the OnAir console range. But then the
Vista’s D950System.ini files need to be adapted accordingly.
A.5.9 Audio Sync for all Systems
All systems being part of the network that can exchange audio via tie lines
must be properly synchronized. The best option to do this is having a
Studer D21 MasterSync unit feeding word clock in a star configuration to
all the systems involved.
If a single system cannot be synchronized, either AES/EBU cards with
SFCs or analog cards have to be used for tie lines.
To Next Page
Loading...
