Studer Vista - Stereo aux Parameters

Vista Digital Mixing System
3-10 Parameters SW V3.3 Date printed: 05.08.03
3.3.5 Stereo AUX Parameters
Press one of the GLOBAL VIEW: AUX STEREO keys.
The stereo AUX view provides selection of the AUX bus (ON/OFF), send
level adjustment, pre-/after-fader switching, and pan setting.
S AUX On/Off [18] Stereo AUX bus selection. Other stereo AUX bus views can be selected as
well (3...4, 5...6, etc.).
Send Level [19] The send levels for stereo AUX 1 through the maximum number config-
ured can be adjusted using this rotary encoder; adjustment range is from
MUTE (i.e. –∞) through +10 dB.
AUX Panning [20] Either stereo AUX channel can be attenuated, which provides a L/R pan-
ning function.
Pre/Post Selection [21] When the PRE / POST key in the fader bay’s GLOBAL VIEW area is active,
the Vistonics view changes similar to the one shown for mono AUX bus
on the previous page. The signal sent to the stereo AUX bus can be se-
lected pre-fader (before the fader) or post-fader (after the fader).
[18]
[19]
[20]
[18]
[19]
[20]
[21]
[21]