Studer Vista - Page 617

STUDER 07. Mar. 2005 Release Notes Vista 3.5
10/21
6. The console will automatically recall and update the selected snapshots.
Example 2:
Goal:
The value of channel 3 should be lowered by 4dB on the following snapshots: "Snapshot #1",
"Snapshot #3", "Snapshot #5".
These snapshots currently contain the following fader values:
"Snapshot #1": 0dB
"Snapshot #3": -5dB
"Snapshot #5": -10dB
Therefore after the update they should contain the new (relative) updated values:
Snapshot #1": -4dB
"Snapshot #3": -9dB
"Snapshot #5": -14dB
Steps:
1. Make sure the option "Enable Trim mode" in the menu "Option", "Snapshot Automation" is
set.
2. Recall any snapshot
3. Press-and-Hold ISO on channel strip 3. Touch the fader twice in order to put it into TRIM
mode.
4. Lower the fader of channel 3 by 4dB. (The offset value will be displayed on the Vistonics
®
screen!)
5. Select "Snapshot #1" with the mouse
6. Press-and-Hold the CTRL key on the control bay, followed by selecting "Snapshot #3" and
"Snapshot #5"
7. Click on "Recall and Update". Confirm that you want to overwrite those snapshots.
8. The console will automatically recall and update the selected snapshots.
9. Since the console assumes that the controls in TRIM mode were placed into this mode for
the purpose of this update, the operator will be asked whether those controls should be
taken out of TRIM mode.