Soft Engineer programming via the keypad
Installation & Configuration Manual
15 Soft Engineer programming via the keypad
This section provides [Soft] Engineer programming options using the LCD keypad.
For each menu option, the keypad must be in Engineer programming:
1. Enter a valid Engineer PIN (Default Engineer PIN is 1111. For more details,
see Engineering PINs [➙ 102]).
2. Using the up/down arrow keys, scroll to the desired programming option.
3. It is also possible to select a programming option using the keypad digits, enter
the Engineer programming PIN plus the digit as shown in the table below.
If you change one of the programming options, the keypad displays UPDATED
momentarily.
Performs an Unset, Fullset or Partset on the system. See page
Displays a list of the Inhibited zones on the system. See page
Allows the engineer to isolate zones on the system. See page [➙ 149]
Displays a list of the most recent events on the system. See page [➙ 149]
Displays a list of the most recent access to the system. See page
Displays a list of recent alarms.
Allows the engineer to change the Engineer PIN. See page [➙ 150]
Allows the engineer to add, edit or delete users. See page [➙ 150]
Allows the user to add, edit or delete SMS details for users.. See SMS [➙ 155]
See also
TEST [➙ 145]
DOOR CONTROL [➙ 157]
Engineer programming via the keypad [➙ 110]
INSTALLER TEXT [➙ 157]
SET DATE/TIME [➙ 157]
SMS [➙ 155]
To Next Page
Loading...
Need help?
General
