Vanderbilt SPC53 Series - Controller Hardware; Controller Hardware 42 xx;43 xx;53 xx;63 xx

8
Controller hardware
Controller Hardware 42xx\43xx\53xx\63xx
66
Vanderbilt
Installation & Configuration Manual
A6V10276959
01.05.2016
8 Controller hardware
This section describes the controller hardware.
See also
 Powering expanders from the auxiliary power terminals
[➙ 333]
 Wiring the X-BUS interface [➙ 72]
 Wiring an internal sounder [➙ 87]
 Wiring the zone inputs [➙ 83]
 Controller status LEDs [➙ 332]
 Controller status LEDs [➙ 332]
 Powering expanders from the auxiliary power terminals
[➙ 333]
 Wiring the X-BUS interface [➙ 72]
 Wiring an internal sounder [➙ 87]
 Wiring the zone inputs [➙ 83]
8.1 Controller Hardware 42xx\43xx\53xx\63xx
This section describes the controller for the SPC42xx, 43xx, 53 xx and 63xx
models. The SPC5350 and 6350 are described in Controller Hardware SPC5350
and 6350 [➙ 68].
The SPC controller provides 8 on-board wired zones and optional wireless zones.
1
Optional wireless
module
The controller PCB can be factory fitted with a wireless module for use
with wireless (868 MHz) sensors.
2
SPC status LEDs
These 7 LEDs display the status of various system parameters as
+ –
21 3 4
5
6
7
20
19
8
10
1112131415161718
9
19
0V
12 V
SH
2B
2A
1B
1A
12 V
OP6
OP5
OP4
NC
COM
NO
BHO
TR
IN –
IN +
EXP –
EXP +
TX RX GND
T1 C T2 I1
C I2 I3 C
I4 I5 C I6
I7 C I8
21
22