Installation & Configuration Manual
23.25 ATP Category Timings
The following table shows the settings applied for event timeouts, polling intervals
(active and non-active) and polling timeouts (active and non-active) for each ATP
category. For the purpose of ethernet, polling interval and retry interval are
identical. To reduce costs related to GPRS calls, the interval and retry interval for
GPRS paths differ, for example, Cat 3 [Modem] polls once every 25 minutes and
thereafter it polls every 60s for 5 minutes until it times out after 30 minutes. For a
visual overview of the configured polling interval, go to Status - FlexC - Network
Log.
If an ATP is up and active and then goes down, it will remain on active polling
rates for two more polling cycles before converting to the ATP Down polling
intervals.
Polling when ATP Non-
active
To Next Page
Loading...
Need help?
General
