Engineer programming via the browser
Installation & Configuration Manual
If there are alarms on the system, the information message See alarm tab
displays.
17.5.2 Alarms Overview
The Alarms tab shows the following system information:
Alarm Set Sate - shows whether the system was partial or fullset at the time the
alarm was triggered.
Alarm Status - shows the type of alarm (alarm, confirmed alarm etc.)
Bells active - shows if the alarm activated the bells. Click the Silence Bells
button to cancel.
For each area, the Alarm Set State, Alarm Status, Alarm Activations and Alarm log
displays. The Alarm Activations show a list of zones in alarm state ordered by
activation. Click the Restore button to clear. The Alarm log shows up to 20 events.
17.5.3 Viewing Video
The Video tab displays images from up to 4 IP cameras.
In Full Engineer, Soft Engineer and User mode, select SPC Home > Video.
To Next Page
Loading...
Need help?
General
